Installing The Traction-Control Linkage - Toro Power Max Heavy Duty 1028 OHXE Operator's Manual

4. Squeeze the lever fully, then check the gap
between the bottom of the handle and the end
of the wheel-clutch lever
3

Installing the Traction-Control Linkage

No Parts Required
Procedure
Figure 7
(Figure 8).
g248021
Note:
The gap should be approximately the
thickness of a pencil (1/4 inch or 6 mm). If it is
greater, loosen the cable-clamp nut, slide the
cable jacket up slightly, tighten the cable-clamp
nut, and check the gap again.
5. Repeat steps 2 through 5 for the other cable.
7
Figure 8
g001306
g263628