Intel Shooting Star Mini Quick Start Manual page 11

Temperature: The current temperature of the Drone at the time the last update was received.
Version Patch: The current firmware version of the Drone.
2.3.1.4 Side View
Within the Side View, the operator will be able to access key commands for the Intel® Shooting Star
Mini™ system.
2.3.1.4.1 Periphery
Currently, the functions featured on this tab are only used for outdoor drone light shows.
2.3.1.4.2 Show
Audio / Load: This will load an audio file to be used during the animation.
Audio / Start: This function allows for manual start of audio playback.
Animation / Load: This will load an animation file to be used for a flight.
Animation / Upload: This will upload the animation file to be used for a flight via network to the
Drones.
Parameters / Transmit Parameters: This will transmit the previously loaded parameters to the
Drones via ILT.
Start and Landing / Compute: This will initiate the optimisation algorithm and allocate the specific
Drones to be used for the flight.
Start and Landing / Transmit Optimisation: This will transmit the optimisation data to the Drones
via ILT.
Timecode / Start: Starts timecode
Show Controls / Transmit Times: This transmits timecode synchronization data to Drones via ILT.
Show Controls / Arm Timed Show: Arms the Drones for launch.
2.3.1.4.3 Manual
Flight Commands / Launch and Hover Selected: This command will power on the Drone's motors
and cause it to take-off vertically to 2m height above ground. The Drone will remain in this position
until a landing command has been sent.
2.3.1.4.4 Settings
Indoor Positioning / Try Reconnect: This command will connect the Drones to the ILT network.
Indoor Positioning / Reset Localization Time: This command will synchronize timing of drones
with Control Center.
Firmware / Load: This will load a firmware to upload to Drones.
Firmware / Upload / Stars: This will upload firmware to Drones.
© Intel
11