IKEA ISANDE Manual page 21

ENGLISH
Problem
The compressor does not
start immediately after
pressing Fast Freezing, or
after the change of the tem-
perature.
The compressor does not
start immediately after
pressing Shopping, or after
the change of the tempera-
ture.
Water flows inside the re-
frigerator.
Water flows on the floor.
Temperature cannot be set.
Temperature cannot be set.
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
Possible cause
This is normal, no error has
occurred.
This is normal, no error has
occurred.
Food products prevent
water from flowing into the
water collector.
The melting water outlet is
not connected to the evap-
orative tray above the
compressor.
The Shopping is switched
on.
The Fast Freezing function
is switched on.
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
Solution
The compressor starts after
some time.
The compressor starts after
some time.
Make sure that food products
do not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Switch off Shopping manually,
or wait until the function resets
automatically to set the tem-
perature. Refer to " Shop-
ping".
Switch off Fast Freezing func-
tion manually, or wait until the
function resets automatically
to set the temperature. Refer
to "Fast Freezing function".
Keep the Function pressed for
approximately 10 seconds un-
til a long sound is heard and
display shuts off for a short
time.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
21