Basic Operation; Charging The Battery; Turning The Headset On And Off; Checking The Battery Status - Wear & Hear BeHear ACCESS User Manual

Hide thumbs Also See for BeHear ACCESS:
Table of Contents

Advertisement

BeHear ACCESS User Manual

Basic Operation

Charging the Battery

Charging the battery lasts approximately three hours. We recommend to charge the battery
before using your BeHear ACCESS headset for the first time.
To charge the battery using the cradle:
1. Plug the larger end of the supplied cable into a standard AC
outlet USB charger adapter, or into the USB port of a
computer, and the cable's smaller end into the Micro USB
port of the charging cradle.
2. Place the BeHear ACCESS headset into the cradle. Line up
the embedded magnets in the headset to the contacts in the
charging cradle. The LED will light up when the headset is
positioned properly.
3. A vibration in the headset indicates that charging has
started. During charging the LED on the neck band will be red, turning green when BeHear
ACCESS is fully charged.
To charge the battery directly by the cable:
1. Plug the larger end of the supplied cable into a standard
AC outlet USB charger adapter, or into the USB port of a
computer.
2. Plug the cable's smaller end into the Micro USB port
located in the BeHear ACCESS neck band.
3. A vibration in the headset indicates that charging has
started. During charging the LED on the neck band will be
red, turning green when BeHear ACCESS is fully charged.
Note: The BeHear ACCESS headset should not be used while charging.

Turning the Headset ON and OFF

To turn on BeHear ACCESS:
Press and hold down the Power button
until the unit vibrates and the LED turns light blue.
To turn off BeHear ACCESS:
Press and hold down the Power button
until the unit vibrates and the LED turns light blue.
Note: Vibration can be disabled by changing a setting in the W&H BeHear application.

Checking the Battery Status

You can view an estimate of the remaining battery charge in either of two ways.

Checking the Battery Level using the Headset

When the device is powered on, quickly press the Power button
notification LED flashes for 1-2 seconds indicating battery level, as follows:
Product Name: BeHear ACCESS
on the neck band
on the neck band
Product No.: ABH-120
Page 8 of 39
LED
on the neck band. The
Doc. No. BHAUM202012.31

Advertisement

Table of Contents
loading

This manual is also suitable for:

Abh-120

Table of Contents