Devatec ELECTROVAP MC2 Technical Manual page 42

E
LECTRO
Management system
Configuration changing menu
Continued
This allows to adjust how frequent the perfume
injections must be (from 1 to 99 mn).
This allows to adjust how long the disinfection
injection time must be (from 1 to 99 mn). This
requires the optional disinfection system.
For the time bath version, this allows to pre-
set the running time up to 8 hours.
This allows to adjust the estimated number of
produced steam in kg or of working time
before a visual control be made. If a cylinder
maintenance is to be done, please refer to
the cylinder maintenance pages of this
manual. If not, this parameter can be adjusted
for a higher value (factory default time : 300h).
This parameter allows to adjust the time of the
small drain (0 to 10 sec) that takes place
whenever the humidifier takes in water. This
time can be increased when foam is seen
inside the cylinder (particularly when using
softened waters).
This allows to shut down the contactor(s)
during draining to prevent leakage currents.
This allows to select how the unit reduces its
output : either by evaporation (required for
demineralized water) or by draining.
This allows to select the type of cylinder used.
V MC2 S
AP
PERFUME FREQUENCY ----
DISINFECTION
DURATION ---- MIN
TIME BATH ---- MIN
MAINTENANCE
TERVAL ------- KG
MAINTENANCE
QUENCY --------- H
FOAM / SCALE
POWER OFF IF
NING : yes or no
ADJUST STEAM BY : ------
CYLINDER SELECT
--------------------
42
B
TEAM ATH
MIN
IN-
FRE-
CON-
TROL
DRAI-
----------
Pictures for illustrating purposes only