❸
• Place the two module wires
through the bottom opening of
the water heater.
• Attach each module wire to the
two screws labeled Terminal for
Controls.
Partially unscrew each of the
−
two screws.
Insert the spade terminal
−
(connected to the end of each
wire) between the screw and
the contact.
Tighten the screws.
−
Replace and tighten the four screws on the water
❹
heater cover.
❺
Plug in the water heater power cord.
Turn on the water heater by pressing the On/Off
❻
button on the water heater controller.
Remote control
cable