Advertisement
4.3 End Closer Instructions (XE100, XE200, XE400)
4.3.1 Remove external housing connectors if present. Loosen last
housing screws on top and bottom of duct. Slip end closer over
duct, engaging loosened screws. Tighten screws to retain end
closer. (See Figure 5)
5.0 XJ-L Bus Plug Installation and Removal Instructions
5.1 General Information
5.1.1 XJ-L Bus plugs are available with molded case circuit breakers or Vacu-Break® fusible switches. Bus plugs may be
operated with a pull-chain or hookstick from the floor. Lightweight and portable, plugs are easily moved from one
location to another. Captive hardware allows for easy removal and re-installation.
5.1.2 The bus plug contact fingers are lubricated with an oxide inhibiting grease at the factory. This grease should not be
removed.
5.1.3 Types of XJ-L Bus Plugs:
XQ Series
3 Cir. XPM Series
XQ-R Series
6 Cir. XPM Series
X100, X200
XLEC Series
4
X400
Figure 5
XEC Series
XLVB Series
Advertisement
