Setup; Installing The Blade-Control Bar; Assembling And Unfolding The Handle - Toro Recycler 20958 Operator's Manual

Setup

Important: Remove and discard the protective plastic
sheet that covers the engine.
1
Installing the Blade-Control
Bar
No Parts Required
Procedure
Install the blade-control bar into the upper handle
2
Assembling and Unfolding the
Handle
No Parts Required
Procedure
1. Install the handle ends onto the mower housing so that
the pin attached to each handle bracket is in the lower
hole of its related handle end
(Figure
Figure 4
(Figure 5).
1. Pin
Note: The pins do not show through the holes in the
handle ends when the handle is in the folded position.
4).
2. Remove and save the 2 handle knobs and 2 carriage
bolts from the handle brackets
g003116
1. Handle knob
3. Unfold the handle to the operating position by rotating
it rearward
4
Figure 5
2. Handle end
(Figure
Figure 6
2. Carriage bolt
(Figure 7).
g032866
6).
g032865