Door" Message; Interrupting Or Restarting A Programme; Altering The Settings - Miele M 2240 SC Operating Instructions Manual

Hide thumbs Also See for M 2240 SC:
Table of Contents

Advertisement

the power level may be reduced, and
this is shown in the display (protection
against overheating).
The time required depends on:
– the initial temperature of the food.
Food taken straight from the
refrigerator takes longer to cook than
food which has been kept at room
temperature.
– the type and texture of the food.
Fresh vegetables contain more water
and cook more quickly than stored
vegetables.
– the frequency of stirring or turning
the food.
Frequent stirring or turning heats the
food more evenly, and it is therefore
ready in a shorter time.
– the amount of food.
As a general rule, allow approx. time
and a half for double the quantity.
For a smaller quantity, shorten the
duration accordingly.
– the shape and material of the
container.

"door" message

The "door" message in the display is a
reminder that the appliance should not
be used without food inside it.
Operating the appliance without food
can damage the appliance.
If the Start sensor is touched without
the door having first been opened, the
word door appears in the display. If the
door has been closed for 20 minutes or
longer, it could mean that there is no
food in the microwave oven. This is to
remind you to open the door and make
sure there is food in the microwave
oven before starting a cooking process.
Start is blocked until the door is
opened.
Interrupting or restarting a
programme
At any time you can . . .
. . . interrupt a programme:
 Touch the Stop/C sensor or open the
appliance door.
The time stops counting down.
. . . continue a programme:
 Close the door and touch Start.
The programme will continue.

Altering the settings

If you discover after starting a
programme that . . .
. . . the microwave power level is too
high or too low, you can
 select a new level.
. . . the duration set is too short or too
long, you can
 interrupt the programme (touch the
Stop/C sensor once), use the arrow
sensors to set a new time and
continue the programme (touch the
Start sensor).
Or alternatively:
 The cooking duration can be
increased by touching Start during
operation. Each time Start is touched,
the cooking duration is increased by
another minute (exception: the
cooking time increases in increments
Operation
33

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents