Toro Pro Sneak 365 Operator's Manual page 26

3. Remove the filler cap and the drain plug
28).
1. Oil-drain plug
4. When the oil has drained completely, install the
drain plug.
Note:
Dispose of the used oil at a certified
recycling center.
5. Slowly pour approximately 80% of the specified
amount of oil in through the valve cover.
6. Check the oil level; refer to
Engine-Oil Level (page
7. Slowly add additional oil to bring the level to the
upper hole on the dipstick.
8. Replace the fill cap.
Changing the Oil Filter
1. Drain the oil from the engine; refer to
the Engine Oil (page
2. Place a shallow pan or rag under the filter to
catch the oil.
3. Remove the old filter
surface of the gasket seal on the filter head.
Figure 28
Checking the
25).
Changing
25).
(Figure 29) and wipe the
(Figure
1. Oil filter
g025666
4. Apply a thin layer of clean oil to the gasket seal
of the new oil filter.
5. Apply a thin coat of the clean oil of the proper
type through the center hole of the filter.
6. Allow 2 minutes for the oil to be absorbed by the
filter material, then pour off any excess oil.
7. Install the replacement oil filter to the filter
adapter by turning the oil filter clockwise until the
rubber gasket contacts the filter adapter, then
tighten the filter an additional 1/2 turn.
8. Fill the crankcase with the proper type of new
oil; refer to
9. Start the engine and let it run for 30 seconds.
Shut off the engine and let the machine cool.
10. Check the engine oil level; refer to
Engine-Oil Level (page
26
Figure 29
Servicing the Engine Oil (page
25).
g020436
25).
Checking the