Toro Pro Sneak 365 Operator's Manual page 37

Figure 43
1. Hose clamp
6. Remove the left side cover plate and loosen the
3 hose clamps under the hydraulic tank
44).
Figure 44
1. Hose clamp
7. Disconnect the electrical lead to the oil
temperature sending unit at the bottom of the
reservoir.
8. Loosen the hydraulic tank straps and remove
the hydraulic tank from the machine
g026669
9. Flush the reservoir with cleaning solvent.
10. Remove the elbow adapters and remove and
(Figure
clean the filter screens with compressed air
(Figure
g026670
11. Put thread sealant on the threads of the suction
screen and install the screen, elbow, hose, and
clamp.
(Figure 45).
12. Connect the electrical lead to the oil temperature
sending unit at the bottom of the reservoir.
13. Install the hose to the tank and secure the
clamps.
14. Install the hydraulic tank assembly.
15. Fill the hydraulic tank with approximately 25.8
L (6.8 US gallons) of Toro premium all season
hydraulic fluid ISO VG 46.
Dispose of the used oil at a certified recycling
center.
16. Install the dipstick cap.
37
Figure 45
46).
Figure 46
g026707
g026671