Shutting Off The Machine; Removing The Battery Pack From The Machine; Operating Tips - Toro Flex-Force Power System 20367 Operator's Manual

Shutting Off the Machine

1. Release the blade-control bar (A of
2. Remove the electric-start button from the electric
starter (B of Figure
3. Remove the battery pack; refer to
Battery Pack from the Machine (page
Note:
Whenever you are not using the machine,
remove the battery pack.
Figure 12
Removing the Battery Pack
from the Machine
1. Lift up the battery-compartment lid.
2. Press the battery-pack latch to release the
battery pack and remove the battery pack.
3. Close the battery-compartment lid.

Operating Tips

General Mowing Tips
•
Inspect the area where you will use the machine
and remove all objects that the machine could
throw.
•
Avoid striking solid objects with the blade. Never
deliberately mow over any object.
•
If the machine strikes an object or starts to vibrate,
immediately shut off the motor, wait for all moving
parts to stop, remove the battery, and examine the
machine for damage.
•
For best performance, install a new Toro blade
before the cutting season begins or when
necessary.
Cutting Grass
•
Cut only about a third of the grass blade at a time.
For improved quality of cut, runtime, and bagging,
cut grass at a higher height of cut.
Figure
12).
Removing the
14).
•
Do not cut below 51 mm (2 inches) unless the
grass is sparse or it is late fall when grass growth
12).
begins to slow down.
•
When cutting grass over 15 cm (6 inches) tall,
mow at the highest cutting height setting and walk
slower; then mow again at a lower setting for the
best lawn appearance. If the grass is too long, the
machine may plug and cause the motor to stall.
•
Wet grass and leaves tend to clump on the yard
and can cause the machine to plug or the motor to
stall. Avoid mowing in wet conditions.
•
Be aware of a potential fire hazard in very dry
conditions, follow all local fire warnings, and keep
the machine free of dry grass and leaf debris.
•
Alternate the mowing direction. This helps
disperse the clippings over the lawn for even
fertilization.
•
If the finished lawn appearance is unsatisfactory,
try 1 or more of the following:
g296945
– Replace the blade or have it sharpened.
– Walk at a slower pace while mowing.
– Raise the cutting height on your machine.
– Cut the grass more frequently.
– Overlap cutting swaths instead of cutting a full
swath with each pass.
Cutting Leaves
•
After cutting the lawn, ensure that half of the lawn
shows through the cut leaf cover. You may need
to make more than a single pass over the leaves.
•
If there are more than 13 cm (5 inches) of leaves
on the lawn, mow at a higher cutting height and
then again at the desired cutting height.
•
Slow down your mowing speed if the machine
does not cut the leaves finely enough.
14