Table of Contents
Advertisement
FCC Part 15 C Notice
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
This equipment complies with FCC/ IC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator and
your body.
Cet équipement est conforme aux limites d'exposition aux radiations FCC/IC établies pour un
environnement non contrôlé. Cet équipement doit être installé et utilisé avec une distance minimale de 20
cm entre le radiateur et votre corps.
INDUSTRY CANADA NOTICE: CANADA ONLY.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,Science and Economic Development
Canada's licence-exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation,Sciences et
Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes :
1. L'appareil ne doit pas produire de brouillage;
2. L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
This product is manufactured by Amax Group
12645 Memorial Drive Suite F1 #388 Houston, TX 77024
Propel™ and Propel RC™ are the licensed trademarks of Rooftop Group LTD Singapore.
©2020 All rights reserved. Visit us at www.propelrc.com
CAN ICES-3(B)/NMB-3(B)
This product meets the applicable Innovation, Science and Economic Development Canada
technical specifications.
Conforms to safety requirements of FCC, RSS247, RSS210.
Costco Wholesale Canada Ltd.*
415 W. Hunt Club Road
K2E 1C5, Canada
* faisant affaire au Québec sous
le nom les Entrepôts Costco
15
WARNING!
CHOKING HAZARD - Small parts.
Ottawa, Ontario
Not suitable for children under 3 years.
1-800-463-3783
www.costco.ca
Made in China
CT-6168
C004-CA-V1.0
FLEX 2.0
Compact Folding Drone with HD Camera
INSTRUCTION BOOKLET
WARNING: Never leave product charging unattended for extended periods of
time. Always disconnect the battery from charger immediately after the battery
is fully charged. Please refer to enclosed safety instructions.
PACKAGE CONTAINS:
FLEX 2.0™
2.4G Wireless
Spare Parts
Controller
Colors and styles may vary slightly.
TM
ON BOARD
ON BOARD
HD CAMERA
HD VIDEO
1280 x 720 pixel
20 frames per second
USB Charger
Phone Holder
Battery
Instruction
Manual
PROPEL
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Propel Trampolines FLEX 2.0
Summary of Contents for Propel Trampolines FLEX 2.0
- Page 1 FCC Part 15 C Notice FLEX 2.0 CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
-
Page 2: Table Of Contents
Recognizing The Front & Rear Of The FLEX 2.0™ ......5 4×1.5 volt “AAA”... -
Page 3: Flex 2.0™ Diagram
1. Before starting, make sure that the power on your controller is off and the battery is removed from the FLEX 2.0™. Make sure that there are no other 2.4G devices in the area. 2. Insert the battery into the FLEX 2.0™ and set it down on a flat level surface. Push down the power button CONTROLLER DIAGRAM and hold for a few seconds (see diagram D1).The red and white LED lights on the drone should begin to flash... -
Page 4: Now You Are Ready To Fly
Below is a list of basic flight functions for your long-range remote to control the FLEX 2.0™. While learning to fly your FLEX 2.0™ it is best to start in a large space with the drone facing away from you until you get used to the basic controls. -
Page 5: Adjusting The Trim
1. Place the FLEX 2.0™ on a flat level surface Forward/Backward Trim 2. Make sure the FLEX 2.0™ is on and that the controller is synced (refer to syncing pg 4). Do not start the • If your FLEX 2.0™ drifts forward while in the air, blades. -
Page 6: Live Video Streaming Setup
FLEX 2.0™ ‘s camera. 1. One Apple or Andriod phone* (not included) 2. This App also allows you to control your FLEX 2.0™ by your mobile device. To activate the control sticks, 2. Propel 1890 APP installed (app store or Andriod market available) tap the “ON”... -
Page 7: Troubleshooting Your Flex 2.0
Crash landing at high-speed may cause damage to your FLEX 2.0™’s propellers. 1. The FLEX 2.0™ has four sets blades, two sets blades with indication number B & A on front, and two sets blades with indication number A & B on the rear (see the diagram V). -
Page 8: Warnings
Stand away from the FLEX 2.0™ to reduce the risk of getting into the flight path. Warn spectators that you will be flying your FLEX 2.0™ so that they are aware of its position.
Need help?
Do you have a question about the FLEX 2.0 and is the answer not in the manual?
Questions and answers