Advertisement
Quick Links
Trim size 4.5 x 6.875 in.
Spread size 9 x 6.875 in.
FCC Part 15 Notice
CAUTION:Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE:This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against
harmful interference in a residential installation.This equipment generates,uses and can radiate radio
frequency energy and,if not installed and used in accordance with the instructions,may cause harmful
interference to radio communications.However,there is no guarantee that interference will not occur in a
particular installation.If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on,the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions :
(1) This device may not cause harmful interference,and
(2) this device must accept any interference received,including interference that may cause undesired
operation.
INDUSTRY CANADA NOTICE: CANADA ONLY.
This device complies with Industry Canada licence-exempt RSS standard(s).Operation is subject to the following two conditions:
(1) this device may not cause interference,and (2) this device must accept any interference,including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.L'exploitation
est autorisée aux deux conditions suivantes :(1) l'appareil ne doit pas produire de brouillage,et (2) l'utilisateur de l'appareil doit
accepter dout brouillage radioélectrique subi,même si le brouillage est susceptible d'en compromettre le fonctionnement.
WARNING!
CHOKING HAZARD - Small parts.
Not suitable for children under 3 years.
Conforms to safety requirements of ASTM, CPSIA and FCC.
©2016 Rooftop Brands™ All rights reserved
Tel:+ (1) 949-566-9573 • www.propelrc.com
PROTON™ MICRO DRONE
INDOOR / OUTDOOR WIRELESS QUADROCOPTER
WARNING: Never leave product charging unattended for extended periods of
time. Always disconnect the Proton™ from charger immediately after it is
fully charged. Please refer to enclosed safety instructions.
Proton™
2.4G Wireless Controller
V1
Made in China
INSTRUCTION BOOKLET
PACKAGE CONTAINS:
Spare Parts
USB charging cord
Colors and styles may slightly vary.
Instruction Manual
Advertisement
Related Manuals for Propel Trampolines PROTON MICRO DRONE
Summary of Contents for Propel Trampolines PROTON MICRO DRONE
- Page 1 Trim size 4.5 x 6.875 in. Spread size 9 x 6.875 in. FCC Part 15 Notice PROTON™ MICRO DRONE CAUTION:Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. INDOOR / OUTDOOR WIRELESS QUADROCOPTER NOTE:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against...
-
Page 2: Table Of Contents
TABLE OF CONTENTS FEATURES • Built-in 6axis gyro chip for extremely stable flight. Product Features ............2 •... -
Page 3: Proton™ Diagram
PROTON™ DIAGRAM WARNING Rear Rotor Blades DO NOT FLY YOUR PROTON™ IN FOUL WEATHER! Charging Socket SYNCING YOUR PROTON™ Important! When syncing your Proton™ quadrocopter with the controller always make sure that the quadrocopter is on a flat level surface and that your digital trim settings are in the center Landing Gear position. -
Page 4: Recognizing The Front & Back Of The Proton
3 CHANNEL FLIGHT CONTROLS (BEGINNER FLYING) RECOGNIZING THE FRONT & BACK OF THE PROTON™ Below is a list of basic flight functions for your long-range remote control Proton™.While learning to fly Even though the Proton™ has four rotors,there is still a“front”or forward facing direction and "back" or backwards facing direction.The front and forward facing direction of the Proton™... -
Page 5: Understanding Trim Adjustments
PERFORMING A 360º STUNT ROLL UNDERSTANDING TRIM ADJUSTMENTS Forward/Backward Trim Once the Proton™ is airborne, • If your Proton™ is drifting forwards or backwards,you may need to adjust the FORWARD/BACKWARD 1. Press the right control lever straight down. TRIM (see diagram O). 2. -
Page 6: Trouble Shooting
TROUBLESHOOTING YOUR PROTON™ PROTON™ WARNING: The Proton™ is designed for INDOOR or OUTDOOR flight. Proton™‘s blades revolve at high speeds and can PROBLEM POSSIBLE REASON SOLUTION cause damage to the user,spectators and animals.Stand away from the Proton™ to reduce the risk of getting into the flight path.Warn spectators that you will be flying your Proton™...