Table of Contents
Advertisement
FCC Part 15 C Notice
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
INDUSTRY CANADA NOTICE: CANADA ONLY.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter dout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
WARNING!
CHOKING HAZARD - Small parts.
Not suitable for children under 3 years.
Conforms to safety requirements of RSS210 and FCC.
©2018 Rooftop Brands™ All rights reserved
11
Palm Sized High Performance Drone
WARNING: Never leave product charging unattended for extended periods
of time. Always disconnect X09 from charger immediately after the X09 is
fully charged. Please refer to enclosed safety instructions.
X09
2.4G Wireless Controller
Made in China
V 1.0
X09
INSTRUCTION BOOKLET
PACKAGE CONTAINS:
USB Charging Cord
Spare Parts
Colors and styles may vary slightly.
Instruction Booklet
Advertisement
Table of Contents
Related Manuals for Propel Trampolines X09
Summary of Contents for Propel Trampolines X09
- Page 1 INSTRUCTION BOOKLET WARNING: Never leave product charging unattended for extended periods of time. Always disconnect X09 from charger immediately after the X09 is fully charged. Please refer to enclosed safety instructions. PACKAGE CONTAINS: WARNING! CHOKING HAZARD - Small parts.
-
Page 2: Table Of Contents
................... . . 5 1. Before playing, you need to charge the X09 battery first. Connect the USB charging T (Training) Mode . -
Page 3: Preparing For Flight
Make sure to be in a large space with an open radius of at least 50 feet. Make sure the empty space has no obstacles or rivers. Set your X09 on a clean flat surface before take-off. DO NOT ATTEMPT TO FLY YOUR X09 IF THERE IS RAIN, SNOW, HEAVY WINDS, THUNDER OR LIGHTNING OUTDOORS. -
Page 4: Now You Are Ready To Fly
Forward/Backward Trim If you have successfully synced your X09 to your controller as explained on page 4 you are now ready to fly. Before beginning to fly your drone you should familiarize yourself with how to start and stop the rotors, how to use your take off and auto land feature and how the controls work. -
Page 5: Channel Flight Control
PRESS the Throttle Control stick vertically down then release again, you will hear 4 short beeps indicating the X09 is now set to 4CH 3 CHANNEL FLIGHT CONTROL mode. For beginner pilot, you may want to practice in 3 CHANNEL mode first. Press the direction control stick vertically down, you will hear a beep and now you are in 3 CHANNEL mode. -
Page 6: Calibrating The X09
Stand away from the X09 to reduce the risk of getting into the flight path. Warn spectators that you will be flying your X09 so that they are aware of its position. Before flight, inspect the rotor blades to make certain of flying, you may need to calibrate the internal that the blades are securely fastened to the X09.
Need help?
Do you have a question about the X09 and is the answer not in the manual?
Questions and answers