Solving Problems; General; Troubleshooting Table - Asko CC96264W Instructions For Use Manual

SOLVING PROBLEMS

General

If you notice a crack in the glass top (however small), switch the hob Off immediately, unplug
the hob, turn Off the (automatic) fuse switch(es) in the meter cupboard or, in the event of a
permanent connection, set the switch in the power supply lead to zero. Contact the service
department.

Troubleshooting table

When in doubt on the proper operation of your appliance, this does not automatically mean there
is a defect. Try to address the problem yourself first by checking the points mentioned below or
for more information visit the 'www.asko.com' website.
Problems with the hob
A slight smell is noticeable the first
few times the hob is used.
The hob is not working.
A fuse blows as soon as the hob is
switched on.
Other fault codes.
Problems with the oven
The oven doesn't work.
There is smoke during use of
the oven
Possible cause
The new appliance is heating up.
There is no power supply due
to a defective cable or a faulty
connection.
The appliance is incorrectly
connected.
Defective generator.
Possible cause
No oven function set
No temperature set.
No power supply.
Normal during first use.
Solution
This is normal and will disappear
once it has been used a few
times. Ventilate the kitchen.
Check the fuses or the electric
switch (if there is no plug).
Check the electrical connections.
Contact the service department.
Solution
Choose the oven function
using the oven functions knob
(see 'Operating the oven').
Set the temperature using the
temperature knob
(see 'Operating the oven').
Check that the electricity
is working properly (fuse in
the circuit breaker box/ plug
in the socket).
Clean the oven regularly.
Reduce the amount of fat or
oil in the baking tray.
EN 23