Advertisement
Quick Links
Fitting Guide
Roger and Cochlear Implants
This guide provides detailed information on how Roger should be used with the most popular cochlear implant sound processors.
Set-up
The table below shows the Roger receiver and/or adaptor that is required to use Roger with each sound processor.
Advanced Bionics sound processors
All Naída CI Q models
2
Roger 17
or ComPilot + Roger X
SONNET
Roger 21
or FM Battery Pack Cover +
Roger X
1
Jace Wolfe (2013), Evaluation of speech recognition of cochlear implant recipients using a
personal digital adaptive radio frequency system.
2
TM
PowerCel
170 battery required.
Neptune™
Neptune Connect +
Roger X
MED-EL audio processors
OPUS 2
FM battery Pack Cover +
Roger X
Journal of the American Academy of Audiology.
Cochlear sound processors
Nucleus 7 (CP1000)
Roger 20
or Mini Microphone 2+ with
Roger X
RONDO
Mini Battery Pack + Roger X
Nucleus 6 (CP910)
Nucleus 5 (CP810)
Roger 14
or Euro accessory adapter +
Roger X
Oticon sound processors
Neuro One
Roger X
Advertisement
Related Manuals for Phonak AB Naida CI Q Series
Summary of Contents for Phonak AB Naida CI Q Series
- Page 1 Fitting Guide Roger and Cochlear Implants This guide provides detailed information on how Roger should be used with the most popular cochlear implant sound processors. Set-up The table below shows the Roger receiver and/or adaptor that is required to use Roger with each sound processor. Advanced Bionics sound processors Cochlear sound processors All Naída CI Q models...
- Page 2 Pre-fitting To ensure maximum benefit from the Roger system, program the sound processor with the recommended settings according to the table below. Model Recommended sound processor setting Set the Audio Mixing Ratio (Mic/Aux) to 50/50 AB Naída CI Set the ComPilot Mixing Ratio to 50% AB Naída CI via ComPilot AB Neptune Set the Audio Mixing Ratio (Mic/Aux) to 50/50...
- Page 3 Connect the Roger system to your patient’s CI microphone. The user should now report they have heard the Step 1: Attach Roger receiver Switch all equipment off. If required, remove the standard cover or confirmation beeps (a low tone followed by a high tone). hook and attach the adapter to the sound processor.
- Page 4 Troubleshooting Most probable cause Solution Signal from Roger microphone cannot be heard Sound processor is set in the wrong program Switch the sound processor to the dedicated DAI, EXT, ComPilot or AUX program Roger receiver is not connected to the Roger microphone Connect Roger receiver with the Roger microphone (see Step 3) Roger microphone is not switched on or is muted Switch on the Roger microphone and make sure it is not muted...