Advertisement
Pre-fitting
To ensure maximum benefit from the Roger system, program the sound processor with the recommended settings according to the table
below.
Model
AB Naída CI
AB Naída CI via ComPilot
AB Neptune
Cochlear Nucleus 7
Cochlear Nucleus 6 / 5
MED-EL SONNET / Rondo / OPUS 2
For Cochlear's Nucleus 6, Nucleus 5 or the Advanced Bionics Neptune systems, Roger X* should be programmed. This will disable
AutoConnect and will ensure that the Roger X output impedances match the input impedance of the sound processor. A Roger
Touchscreen Mic or Roger inspiro is required for programming Roger X. Please follow the steps below to program the Roger X:
1.
Connect Roger X to the sound processor or ComPilot and switch it on.
Using Roger Touchscreen Mic:
2.
Turn Roger Touchscreen Mic on, hold it close to Roger X (less than 10 cm / 4 inches). Then go into [Settings] and select [Roger
receiver settings].
3. Select [CI Profiles]
4.
Select the corresponding profile as shown in the table below.
5.
Select [EasyGain level].
6.
Set the EasyGain to the corresponding value as shown in the table below.
Using Roger inspiro:
2.
Turn Roger inspiro on, hold it close to Roger X (less than 10 cm/4 inches) and select the function [Check].
3.
Click [Manage], scroll to [CI module] then click [OK].
4.
Scroll to the corresponding setting as shown in the table below and click OK.
5.
Scroll to [EasyGain] and click [OK].
6.
Set the EasyGain to the corresponding value as shown in the table below.
Model
AB Neptune with Roger X
Cochlear Nucleus 6 / 5 with Roger X
MED-EL RONDO / OPUS 2 with Roger X
MED-EL SONNET with Roger X
No programming of Roger X is required for:
-
Advanced Bionics ComPilot
-
MED-EL audio processor
-
Cochlear Mini Microphone 2+
-
Older CI systems using MicroLink CI S
Roger 14, Roger 17, Roger 20 and Roger 21 are pre-configured for the compatible sound processor, that setting cannot be changed.
*
Available for Roger X (02) only
Recommended sound processor setting
Set the Audio Mixing Ratio (Mic/Aux) to 50/50
Set the ComPilot Mixing Ratio to 50%
Set the Audio Mixing Ratio (Mic/Aux) to 50/50
Set Mixing Ratio to 1:1
Set Mixing Ratio to 1:1 and select Autosensitivity
None required
Recommended CI Profile / CI Setting
for Roger X
Profile 4 / Setting 4
Profile 9 / Setting 9
No programming required
Alternatively use Profile 2 / Setting 2
No programming required
Alternatively use Profile 3 / Setting 3
TM
+ ADRO configuration
Recommended EasyGain
for Roger X
+8dB
0dB
0dB
0dB
Advertisement
