Hisense AP-10CR1SEJS Use & Care Manual page 10

NOTE:The symbols may be different from these models, but the functions are similar.
1. Select the mode. See " MODE ".
2. Select the fan speed. See " FAN ".
3. Set the temperature. See "TEMPERATURE".
4. Press POWER button to start the air conditioner.
NOTE:
When the air conditioner is turned on for the first time after it is
plugged in, it will run in the Smart Mode control. When the air
conditioner is turned on at all other times, it will run according to
the previous setting. Smart Mode can be selected with the remote
control only.
Only if the unit is operated in UNLIKELY VERY HUMID air,
water will be collected in the container inside the unit. If the
water container is full, the air conditioner will stop. The
screen will displays "E5" to inform you to empty the internal
container.
Operating modes:
1. Press and release MODE until you see the symbol flashes for the
desired setting.
2. Choose Cooling, Dry, Fan Only or Heating.
Cooling-Cools the room. Press FAN to select High,
Mid or Low. Press the Plus or Minus button to adjust the
temperature.
Dry-Dries the room. The air conditioner automatically selects
the temperature. The fan runs on Low speed only.
Starting Your Portable Air Conditioner
9
NOTE: Dry mode should not be used to cool the room.
Fan Only-Only the fan runs. Press FAN to select High,
Mid or Low.
Heating-heats the room. Press FAN to select high,
Mid or Low. Press the PLUS or MINUS button to adjust the
temperature.
NOTE: Heating is NOT available for cooling only air conditioner.
Fan Speed
1. Press and release FAN to choose the desired fan speed.
2. Choose High, Mid or Low.
Auto-automatically controls the fan speed depending on the
current room temperature and temperature control setting.
High-for maximum fan speed
Mid-for normal fan speed
Low-for minimum fan speed