Installing And Using 10/100/1000Mbps Gigabit Switch; Installing The 10/100/1000Mbps Gigabit Switch; Desktop Installation; Rack-Mount Installation - Encore ENHGS-800 Manual

Hide thumbs Also See for ENHGS-800:

Table of Contents

3. Installing and Using 10/100/1000Mbps Gigabit Switch

The switch does not require software configuration. Users can immediately use

most of the features of this product simply by attaching the cables and turning the

power on.

For desktop installation, the switch needs to put on a clean, flat desk or table

close to a power outlet. Plug in all network connections and the power cord,

then the system is ready.

When deciding where to put the switch, you must ensure:

It is accessible and cables can be connected easily.

Cabling is away from - Sources of electrical noise such as radio,

transmitters, broadband amplifiers, and fluorescent lighting fixtures.

Water or moisture cannot enter the unit.

Air flow around the unit and through the vents in the side of the case is

not restricted (company recommend that you provide a minimum of

25mm clearance).

To prolong the operational life of your units:

Never stack units more than eight sets high if freestanding.

Do not place objects on top of any unit or stack.

Do not obstruct any vents at the sides of the case.

The switch may standalone, or may be mounted in a standard 19-inch

equipment rack. Rack mounting produces an orderly installation when you

have a number of related network devices. The switch is supplied with two

mounting brackets and screws. These are used for rack mounting the unit.

Table of Contents