Speed/Link And Act Led; Fdx Led; The Rear Panel; Power Connecting - Encore ENHGS-800 Manual

Hide thumbs Also See for ENHGS-800:

Table of Contents

2.3.2.1 Speed/Link and Act LED

Every port has three LED(100M, 10M, Activity) for indicating the speed

and connection status.

If the port is connected but the Speed/Link LED(100M/10M) and

Activity(ACT) LED is dark, check the following items:

1. The switch and the connected device's power are on or not

2. The port's cable is firmly seated in its connectors in the switch

and in the associated device.

3. The connecting cable is good and with correct type

4. The connecting device, including any network adapter is functioning.

If the FDX lights amber, it means that the port is under full-duplex

operation or dark for half-duplex mode.

The rear panel of the switch is shown as below.

For compatibility with electric service in most areas of the world, the switch's

power supply automatically adjusts to line power in the range 100-240 VAC

and 50-60 Hz.

Plug the female end of the power cord firmly into the receptacle on the rear

panel of the switch. Plug the other end of the power cord into an electric

service outlet then the power will be ready.

Table of Contents