Firmware Upgrade Instructions for the BayStack 100-series Hubs
Package Contents
Required Tools and Materials
2
This firmware upgrade kit contains the following items:
•
Programmable read-only memory (PROM) chip
•
These upgrade instructions
To replace the 100-series hub firmware, you need the following tools:
•
A #1 Phillips screwdriver to remove the cover from the 100-series hub
•
An industry-approved IC extraction tool or equivalent to extract the
PROM from its socket on the 100-series hub motherboard
•
An antistatic mat and wrist strap (attached to an antistatic leash) to protect
electronic components from static electricity damage
•
The guide Using the BayStack 100-series Hubs (Bay Networks part
number 893-839-C or later) to refer to procedures on installing and
removing the hub
893-00945-A