Memory Of Alarm; Phone Access & Voice Response Capability; Paging Feature; Single-Button Arming Feature - ADT Safewatch Pro 2000 User Manual

SYSTEM OVERVIEW (Continued)
When an alarm condition occurs, the touchpad displays the number(s) of the zone(s) that

Memory of Alarm

caused the problem, and displays the type of alarm (ex. FIRE, ALARM). It remains displayed until
it is cleared by disarming the system (see DISARMING THE SYSTEM section).
Phone Access & Your system may include a voice module that will permit you to access the system via a Touch-
Voice tone phone, either on-premises or by call-in when away. The phone access feature will enable
Response you to do the following:
Capability
• Receive synthesized voice messages over the telephone regarding the status of the
• Arm and disarm the system and perform most function commands via the telephone, with
Complete information regarding the use of this feature is provided in a separate manual entitled
PHONE ACCESS USER'S GUIDE, which accompanies the voice module.
If the paging feature has been programmed for your system, a pager will respond to certain

Paging Feature

conditions as they occur in your system. The pager will display code numbers indicating the
type of condition that has occurred. Refer to the PAGING FEATURE section later in this manual
for detailed information.
Single-Button Paging: The touchpads have a special key (identified as the "D" key) which
may be used to signal a Pager. The message displayed on the pager when this key is pressed is
999–9999. This code could mean "call home", "call your office", or whatever you decide this
code will mean. See SINGLE-BUTTON PAGING FEATURE section.
Single-Button If programmed for your system, keys A and B on the touchpads may have been programmed for
Arming Feature single-button arming without the use of a security code, as follows:
Check with your installer
Key A, when pressed for 2 seconds, will arm all protection (AWAY mode).
if single-button arming is
Key B, when pressed for 2 seconds, will arm the perimeter (STAY mode).
.
present in your system
security system.
voice confirmation provided after each command entry.
– 6 –