Xircom RealPort Ethernet 10/100 User Manual page 19

Parameter
EARLY TRANSMIT ENABLED
FULL DUPLEX
INTERRUPT
I/O PORT
LINE SPEED
LINK INTEGRITY ENABLED
MEMORY ADDRESS 0XD4000
MODE
The network node address can be modified by manually editing
the registry and adding the parameter 'NetworkAddress' with a
hexadecimal string value, such as '0080C7112233'. If the user does
NOT specify a 'NetworkAddress' then the CE3.SYS driver uses the
network node address contained in the RealPort Ethernet 10/100
Card Information Structure.
There are parameters in the Windows NT registry which specify
the configuration of the RealPort Ethernet 10/100 hardware to the
CE3.SYS driver. Many of these parameters correspond directly to
the user-configurable parameters. These parameters are found in
the registry at the following location:
HKEY_LOCAL_MACHINE\SYSTEM\CURRENTCONTROLSET\SERVICES\CE31\PARAMETERS\
The registry parameters are as follows:
Default Valid Values
DISABLED
5
0X320
AUTODETECT
I/O
Windows NT Installation
DISABLED
ENABLED
DISABLED
ENABLED
3, 4, 5, 7,
10, 11, 15
0X200-0X3D0
AUTODETECT
10MBPS
100MBPS
DISABLED
ENABLED
0XA0000 - 0XFE000
I/O
MEMORY MAPPED
3-5
Registry
0
1
0
1
SAME
SAME
0
1
2
0
1
SAME
0
1