Accessories And Attachments; Carton Contents - Hafco Woodmaster SB-12 Operator's Manual

l
Even when all safety measures are taken, some remaining hazards which are not yet evident may
still be present
Electrical Connection
The electric motor is connected in a ready to operate state.
The mains connection at the customer's work place and the extension cable used must correspond to
these regulations.
Faulty electrical connecting leads
Insulation damage often occurs at electrical connecting leads.
Causes include:
l
Pressure marks caused when connecting leads are run through windows or the cracks of doors.
l
Folds caused by the improper attachment of running of the connecting leads.
l
Cuts resulting from the crossing of the connecting lead.
l
Insulation damage caused by the ripping out of the connecting lead from the wall socket.
l
Cracks due to the ageing of the insulation.
Faulty electrical connecting leads such as these must not be used and are highly dangerous due to the
insulation damage.
Check electrical connecting leads regularly for damage. Ensure that the connecting lead is not attached
to the mains supply when you are checking it.
Please choose proper power source, voltage and frequency that are shown on the label for your drill
press.
Extension leads up to 25m in length must have a minimum cross-section of 1.5mm². Extension leads
whose length is over 25m must have a cross-section of at least 2.5mm².
Connections or repairs on the electrical equipment must only be carried out by an electrician.

ACCESSORIES AND ATTACHMENTS

RECOMMENDED ACCESSORIES
To avoid injury:
• Use only accessories recommended for this machine.
• Follow instructions that accompany accessories. Use of improper accessories may cause hazards.
• Use only accessories designed for this table saw to avoid injury from thrown broken parts or work
pieces.
• Do not use any accessory unless you have completely read the instructions or operator's manual for
that accessory.

CARTON CONTENTS

UNPACKING AND CHECKING CONTENTS
Carefully unpack the table saw and all its parts, and compare against the illustration following.
WARNING:
• To avoid injury from unexpected starting, do not plug the power cord into a power source receptacle
during unpacking and assembly. This cord must remain unplugged whenever you are assembling or
adjusting the machine.
• If any part is missing or damaged, do not plug the machine until the missing or damaged part is
replaced, and assembly is complete.
• To protect the table saw from moisture, a protective coating has been applied to the machined
surfaces.
Remove this coating with a soft cloth moistened with kerosene.
WARNING: To avoid fire or toxic reaction, never use gasoline, naphtha, acetone, lacquer thinners or
similar highly volatile solvents to clean the table saw.
5