User
Instructions
Folding Shower Seat Range
M48787 - Folded Shower Seat with Legs
M53552 - Folded Shower Seat with Legs & Padded Seat
General Safety Warning
Please ensure these instructions are fully read
and understood before installation/ use. Retain
these instructions in a safe place for future
reference.
Intended Use
This wall mounted folding shower seat range, with
legs, is intended to be used in a shower to provide a
stable, seated support, where a user is unable to
stand for long periods (i.e. during showering). It can
be folded up against the wall when not in use. The
seat has a small projection of 90mm (3") when folded,
to suit small modern bath and shower rooms.
Unpacking
Remove the product from it's packaging; Check for
damage, if you see any, or suspect a fault, do not
assemble the product. Contact your supplier
immediately.
Safety Information:
·
This Shower Seat must be correctly installed and
maintained
·
It is recommended that this product is installed by
a suitably qualified, competent person.
·
Only install the product in an area where the
mounting surface is structurally sound.
(Strengthening modifications to the fixing surface
may be required.)
·
This product must be secured to the wall using
fasteners which are appropriate to the structural
base material.
Maximum
Load
·
DO NOT install in fibreglass / acrylic shower
enclosures with insufficient stiffness and
strength.
·
The maximum load of this product is 173kg
(27st) based on the product being fitted to a
suitable surface using appropriate fixings and
fitted by a competent person.
·
Waterproofing is recommended, and all fixings
used should be non rusting. Sealant should be
applied around wall contact points to avoid
water ingress.
·
Inspect the product at regular intervals for
wear and damage, do not use if unstable or
the rubber feet are damaged
M53552 Shown