NRS Healthcare Height Adjustable Toilet Seat and Frame User Instructions

P11942 NRS Height Adjustable Toilet Seat and Frame
General Safety Warning
Please make sure that you read and follow
these instructions carefully. Keep these
instructions in a safe place for future reference.
1.

INTENDED USE

The Height Adjustable Toilet Frame with seat and lid is designed to assist those who have difficulty in
lowering onto or rising from a standard toilet. It should be used over a toilet using the splash guard chute
supplied.
USER INSTRUCTIONS
NRS HEIGHT ADJUSTABLE TOILET FRAME & SEAT
Maximum User Weight
2.

SAFETY

Warning: The maximum user weight must not be
more than 190Kg (30st).
3.

UNPACKING

Remove the packaging and check all parts carefully.
Contact your supplier immediately if parts are
missing or damaged and do not try and assemble.
4.

ASSEMBLY/INSTALLATION

Fit the splash guard chute by raising the toilet lid and
seat and placing onto the wire side brackets
5.

IN USE

Adjust to the required height by removing each
'e-clip' in turn.
Slide each leg up or down to the required height.
Align the holes and reinsert the 'e-clip'.
Ensure that all four legs are set at the same height
to prevent rocking. The device may then be placed
over the toilet and is ready for use.
6.

MAINTENANCE

Check the feet monthly for signs of wear.
Check 'e-clips' regularly for signs of wear.Give
instruction explaining when they have it right
7.

CLEANING INSTRUCTIONS.

Clean regularly using a general purpose, neutral
detergent and warm water.
Please check the suitability of the cleaning product
before use. Do not use abrasive cleaners or cloths
as these could damage surfaces and invalidate any
warranty.
To disinfect, wipe with a dilute bleach solution and
rinse thoroughly.
Allow the product to dry prior to use/storage.
1
30st
190kg