BOMANN DT 248 Instruction Manual page 18

Gap to the back and to the side walls each
-
approx. 5 cm;
Place the appliance so that the appliance door
-
can open without being impeded.
• Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
For information on the climate class, please refer
to chapter "Technical Data" or to the rating label
located in the interior or on the rear side of the
appliance.
• Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
• Avoid the installation: Avoid the installation: Avoid the installation: Avoid the installation:
near heaters, next to a stove, direct sunlight or
-
any other heat sources;
at locations with high humidity (e.g. outdoors,
-
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
near volatile or flammable materials (e.g. gas,
-
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
Do not expose the appliance any weather.
-
Electrical connection Electrical connection
Electrical connection Electrical connection
WARNING: WARNING: WARNING: WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock! shock
shock shock
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
CAUTION CAUTION CAUTION CAUTION: : : :
In case of disconnection or power failure:
Wait for approx. 5 minutes before restarting.
-
CAUTION: : : : CAUTION
CAUTION CAUTION
Check the operation settings.
-
• Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reverse the door o Reverse the
Reverse the Reverse the
If required, the door openings can be moved from the
right (supplied condition) to the left side.
WARNING: WARNING:
WARNING: WARNING:
When replacing the door stops, the appliance must
be disconnected from the power supply first.
NOTE: NOTE:
NOTE: NOTE:
• When installing, ask another person to assist.
You possibly need:
•
driver as well as a thin blase screwdriver.
• Remove the hinge cover (1).
Loosen the screws (2) under-
neath and remove the upper door
hinge (3). Open the freezer door a little and lift it
out.
• Loosen the screw (1) and
transfer the door stopper (2)
electric electric electric
to the opposite door underside. Place the door
safely aside.
NOTE: NOTE: NOTE: NOTE:
Keep the door stopper for another possible door
stop reversibility.
• Dismount the middle door
hinge (2) by loosening the
screws (1). Open the fridge
door a little and lift it out.
• Loosen the screw (1) and
transfer the door stopper (2)
18
door opening pening
door o door o pening pening
screw wrench, Phillips screw