Telrad CPE12000 Series User Manual page 19

2. Connect the cable
• Remove the sealing cable gland plug from the gland nut.
• Open the sealing gland nut and remove it. Don not disassembles the gland base from
the bracket.
• Insert the cable into the sealing gland base and connect it to the RJ-45 connector at the
bottom of the CPE. Make sure the connector is completely inserted and tightened.
• Insert the rubber bushing on the cable into the gland base.
• Tighten the gland nut. Use the dedicated tool for fastening the sealing glands.
3. Seal the connector
• Attach the mastic tape (Scotchfil
connector butting up against the connector. Do not over stretch.
• Squeeze to tighten the mastic sealer. Make sure there are no air bubbles.
• Slide the cold shrink sleeve on top of the connector. Make sure that the sleeve covers
both cable connector and unit connector.
• Pull the cord slowly to shrink the sleeve.
LTE Outdoor CPE12000 | User Manual
TM
Electrical Insulation Putty) and wrap it around the
19