Monitoring | Diagnostic Tools - Telrad CPE12000 Series User Manual

Monitoring | Diagnostic Tools

CPE has built-in tools "ping" and "traceroute". "Ping" is used to test if CPE can reach an IP
address or domain by sending the ICMP "ECHO_REQUEST" packet and waiting for the ICMP
"ECHO_RESPONSE" packet. "traceroute" records all the relay points from CPE to an IP
address or domain. The result of "ping" and "traceroute" will be presented in "Diagnostic
Result".
Settings

Status: Enable/Disable the tool.

Diagnostic Type: ping or traceroute.

IP Address/Domain: The IP address or domain name for CPE to connect.

Ping Count (Diagnostic Type: Ping): Stop after sending "Ping Count" packets.

Packet Size (Diagnostic Type: Ping): As titled.

Ping Timeout (Diagnostic Type: Ping): Time to wait for the response packet back to
CPE.

Max Hops (Diagnostic Type: Traceroute): The number of relay point that a packet
can pass by.
Diagnostic Result: The result of "Ping" or "Traceroute" will be shown here.
LTE Outdoor CPE12000 | User Manual
Monitor > Diagnostic Tools
108