Advertisement
4
3 Pilot lights
• The green charging light indicates that the shaver
is connected to the mains.
Model 6520/6515:
After the cell unit is fully charged, the charging
lights starts to flash.
Model 6510:
After the cell unit is fully charged, the green
charging light goes off. If later on, the charging light
comes on again, this indicates that the shaver is
being recharged to maintain its full capacity.
Model 6520/6515 only:
The red low-charge light flashes when the capacity
has dropped below 20 %, provided the shaver is
switches on. The remaining capacity will then be
sufficient for 2 to 3 shaves.
4 Shaving
4.1 Switch lock
The shaver is delivered with switch lock activated
•
(position «
lock»). Push the switch lock to position
•
«
» before you shave for the first time.
To avoid accidentally switching the shaver on,
e. g. when travelling, push the switch lock to
position «
•
lock».
4.2 Switch positions
0 = Off
1 = Shaving with the pivoting head.
The pivoting cutting system automatically adjusts
to every contour of your face.
2 = Shaving with the pivoting head locked ad an angle
(to permit shaving in difficult areas, e. g. under the
nose).
3 = The long hair trimmer is activated
(for trimming sideburns, moustache and beard).
4.3 Shaving with the cord
If the cell unit is discharged, you may also shave
with the shaver connected to the mains
(100 - 240 V
). (If the shaver should not run
immediately, charge it with the switch on position
«0» for approx. 1 minute.)
Tips for the perfect shave
• We recommend to shave before washing,
as the skin tends to be slightly swollen after
washing.
• Hold the shaver at right angles (90°) to the skin.
• Stretch your skin and shave against the direction
of beard growth.
5 Keeping your shaver
in top shape
5.1 Cleaning
• After shaving, switch the shaver off. Press the
release button, take off the triple shaving frame
and gently tap it out on a flat surface.
• Then thoroughly clean the duo cutter block
with the brush as well as the inner area of the
pivoting head.
• About evere four weeks, clean the duo cutter block
with Braun cleaning agents.
5.2 Changing the shaving parts
To maintain optimum shaving performance,
you should replace the triple shaving frame or
the duo cutter block, when these parts are worn.
5
Advertisement
