Toro Groundsmaster 3500-G Operator's Manual page 36

•
2 (per cutting unit) cutting unit spindle-shaft
bearings (Figure 38)
Note:
You can use either fitting, whichever is
more accessible. Pump grease into the fitting
until a small amount appears at the bottom of the
spindle housing (under the cutting unit).
•
2 (per cutting unit) rear roller bearings
Note:
Ensure that the grease groove in each
roller mount aligns with the grease hole in each
end of the roller shaft. To help align the groove
and hole, there is also an alignment mark on an
end of the roller shaft.
Figure 37
Figure 38
(Figure
Figure 39
Important:
cross tube. The bearing blocks are
self-lubricated.
g008904
g008906
39)
g195309
36
Do not lubricate the Sidewinder