Accessories; Troubleshooting Guide - Satelec Acteon Mini LED ScanWave User Manual

It is then recommended that the user leaves the handpiece to cool for a few minutes, until the screen displays the
selected time cycle again and then the light can be switched on again.
V - ACCESSORIES
The following accessories are available for ScanWave
• ScanWave handpiece
• ScanWave battery
• ScanWave charging base
• Power supply
• Light guide Ø7.5mm
• Rigid protection shield
• Light guide Ø5.5mm
• Kit of 5 flexible protective shields, sterilizable, Ø7.5mm
• Kit of 5 flexible protective shields, sterilizable, Ø5.5mm
VI - TROUBLESHOOTING GUIDE
The unit is not repairable in-situ.
All maintenance/repair procedures must be performed in a specialist workshop.
Symptom Possible causes
Battery completely discharged
No operation
(LCD screen Battery defective
off)
ScanWave defective
No operation
(LCD screen ScanWave defective
on)
LED defective and / or dirty
ScanWave defective
Light power
defect or no Defective buttons
light power Insufficiently charged battery
Light guide defective and / or
dirty
8 ● NG39EN020E ● 05/2013 ● (13) ● V5 ● J05451 ●User's Manual ScanWave
Ref F05460
Ref F05451
Ref F05452
Ref X05494
Ref F05470
Ref F05407
Ref F05471 (option)
Ref F61507 (option)
Ref F61505 (option)
Solutions
Recharge battery
Return to SATELEC after-sales department
Put ScanWave back on the charging base
Return to SATELEC after-sales department
Put ScanWave back on the charging base
Return to SATELEC after-sales department
Check cleanliness of LEDs, clean with dry air jet and / or
return to SATELEC after-sales department
Return to SATELEC after-sales department
Return to SATELEC after-sales department
Check charge indicator on the unit's LCD screen, charge the
battery
Clean light guide and / or return to SATELEC after-sales
department