Breaking In The Machine - Toro Greensmaster TriFlex 3300 Operator's Manual

•
Before leaving the operating position (including
to empty the catchers or to unclog the chute), do
the following:
– Park the machine on level ground.
– Disengage the power take-off and lower the
attachments.
– Engage the parking brake.
– Shut off the engine and remove the key.
– Wait for all moving parts to stop.
•
Do not operate the machine when there is the risk
of lightning.
•
Do not use the machine as a towing vehicle.
•
Use accessories, attachments, and replacement
parts approved by The Toro® Company only.
Rollover Protection System
(ROPS) Safety
•
Do not remove the ROPS from the machine.
•
Ensure that the seat belt is attached and that you
can release it quickly in an emergency.
•
Always wear your seat belt if your machine has a
fixed roll bar.
•
Check carefully for overhead obstructions and do
not contact them.
•
Keep the ROPS in safe operating condition by
thoroughly inspecting it periodically for damage
and keeping all the mounting fasteners tight.
•
Replace a damaged ROPS. Do not repair or alter
it.
Slope Safety
•
Slopes are a major factor related to loss of control
and rollover accidents, which can result in severe
injury or death. You are responsible for safe slope
operation. Operating the machine on any slope
requires extra caution.
•
Evaluate the site conditions to determine if the
slope is safe for machine operation, including
surveying the site. Always use common sense
and good judgment when performing this survey.
•
Review the slope instructions, listed below, for
operating the machine on slopes. Before you
operate the machine, review the site conditions to
determine whether the machine can be operated
in the conditions on that day and at that site.
Changes in the terrain can result in a change in
slope operation for the machine.
– Avoid starting, stopping, or turning the machine
on slopes. Avoid making sudden changes in
speed or direction. Make turns slowly and
gradually
– Do not operate a machine under any conditions
where traction, steering, or stability is in
question.
– Remove or mark obstructions such as ditches,
holes, ruts, bumps, rocks, or other hidden
hazards. Tall grass can hide obstructions.
Uneven terrain could overturn the machine.
– Be aware that operating the machine on wet
grass, across slopes, or downhill may cause
the machine to lose traction. Loss of traction
to the drive wheels may result in sliding and a
loss of braking and steering.
– Use extreme caution when operating
the machine near drop-offs, ditches,
embankments, water hazards, or other
hazards. The machine could suddenly roll over
if a wheel goes over the edge or the edge
caves in. Establish a safety area between the
machine and any hazard.
– Identify hazards at the base of the slope.
If there are hazards, mow the slope with a
pedestrian-controlled machine.
– If possible, keep the cutting units lowered to
the ground while operating on slopes. Raising
the cutting units while operating on slopes can
cause the machine to become unstable.
– Use extreme caution with grass-collection
systems or other attachments. These can
change the stability of the machine and cause
a loss of control.

Breaking in the Machine

Refer to the engine manual supplied with the
machine for oil change and maintenance procedures
recommended during the break-in period.
Only 8 hours of operation is required for the break-in
period.
Since the first hours of operation are critical to future
dependability of the machine, monitor its functions and
performance closely so that minor difficulties, which
could lead to major problems, are noted and can be
corrected. Inspect the machine frequently during
break-in for signs of oil leakage, loose fasteners, or
any other malfunction.
21