Table of Contents
Advertisement
Product Overview
Specifications
Frame
Aerating wheels
Shaft
Tines
Bearings
Transport tires (Model 44856
only)
Hitch
Lift mechanism (Model 44856
only)
Springs
Aerating swath
Pattern
Operating speed
Overall width
Weight
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor.
To best protect your investment and maintain optimal
performance of your Toro equipment, count on Toro
genuine parts. When it comes to reliability, Toro
delivers replacement parts designed to the exact
engineering specification of our equipment. For peace
of mind, insist on Toro genuine parts.
Welded tubular steel; divided
into 3 sections, each section
moves horizontally and
diagonally to follow contour,
spring loaded
12 castings, 70 lb, 4 per
section, with permanent roll
pin every other hole
1-1/4 inch, machined to 1 inch
96, 8 per wheel, secured with
1 bolt, roll pin in wheel secures
second hole in tine; 1/2 or 3/4
inch open or closed, 4 inch
slicing blades are available
Self sealed, self aligned
4.80 x 8 — 2 ply
Drop pin (Model 44856)
3 point—Category 1 tractor
type (Model 44867)
Hand hydraulic pump to a 10
inch stroke cylinder. Hydraulic
fluid required is Mobil DTE 15
M or equivalent
6 to assist down pressure on
tines
2 m (78 inches)
15 cm (6 inches) on center
1 to 16 km/h (1 to 10 mph),
depending on conditions
2.2 m (90 inches) (Model
44856)
2 m (82 inches) (Model 44867)
674 kg (1,485 lb) (Model
44856)
569 kg (1,255 lb) (Model
44867)
Operation
Note:
Determine the left and right sides of the towing
machine from the normal operating position.
Preparing to Attach the
Aerator
Service Interval: Before each use or daily
1.
Park the towing machine on a level surface, shut
off the engine, engage the parking brake, and
remove the key.
2.
Visually inspect the towing machine for any
loose hardware or any other possible problems.
Tighten hardware and correct any problems
before operating.
3.
For Model 44856, check the tire pressure and
maintain it at 413 kPa (60 psi).
Attaching the Aerator
Attaching Model 44856
Attach the hitch of the aerator to the tongue of the
towing machine using the hardware of the towing
machine.
Important:
Do not lift the tongue by hand. Use
the tongue jack or powered lift to align the hitch
to the towing machine.
Attaching Model 44867
1.
Lower the 3-point hitch arms of the towing
machine.
2.
Position the aerator so that the 3-point hitch
arms of the towing machine line up with the lift
arms of the aerator.
3.
Attach the arms of the towing machine to the
hitch pins on the aerator lift arms.
4.
Attach the stabilizer bar of the towing machine
to the bolt (3/4 inch x 4 inches) on the top of
the lift arms.
9
Advertisement
Table of Contents
