Adjusting The Auger Cable; Adjusting The Transmission Cable - Toro SnowMax 724 QXE Operator's Manual

Adjusting the Auger Cable

Service Interval: After the first 2 hours
Yearly
If the drive belt slips or squeals under heavy load,
adjust the auger cable.
1. Loosen the nut on the lower cable clamp, but do
not remove it (Figure
Figure 26
1. Nut
2. Cable
2. Pull the cable up to remove some slack
26).
Important:
Do not remove all the slack
from the cable. Removing all the slack from
the cable prevents the auger from stopping
properly.
3. Hold the cable in place and tighten the nut
(Figure 26).
26).
3. Connector
4. Spring
(Figure
Adjusting the Transmission
Cable
Service Interval: After the first 2 hours
Yearly
If the wheels easily stall out, or if the wheels drive
without engaging the self-propel handle, adjust the
transmission cable.
1. Loosen the nut on the upper cable clamp, but do
not remove it
g030444
1. Nut
2. Pull the cable down to remove most of the slack
in the cable
Important:
from the cable. Removing all the slack from
the cable may cause the wheels to engage
without engaging the self-propel handle.
3. Tighten the nut
17
(Figure 27).
Figure 27
2. Cable
(Figure 27).
Do not remove all the slack
(Figure 27).
g030446