User's Interface; Functions Menu - PROEL LED POWER RGB User Manual

User's interface

Use display interface to modify: functions, DMX starting address and to set stand alone mode.
Use the buttons + and - to surf the menu's function.
To enter into the menu, you have to push the Mode button and after that you can search for the desiderate function and
push the Enter button to enter in it.
Push the Enter button to change DMX starting address and press the Enter button to confirm.
In the address view mode, for example A.001, if the point after the letter A is blinking the board is receiving DMX
signal, if the point is static there's no DMX signal.

Functions menu

- A.001
: (dmx address) DMX starting address (first channel).
Default value 001
Go into pushing Enter , choose the value with + and - and push Enter to confirm.
- DM.PA
: (dmx patch) Patch of the board, from 1 to 14 dmx channel.
Default value 7C d
Go to this submenu pushing Mode , choose DM.PA with + and - and push Enter to enter in. Use + and - to select the
desiderate patch and push Enter to confirm
On the table below you can see the summary of the channels, go to page 10 to see the detailed functions.
- DM.DE
: (dmx delay). When DMX signal is missing, the board keeps the last DMX value received for a set period
according to this functions. After the programmed seconds, the board will execute the function according to DM.ST
function, so you can have: black-out, leds on at 15% or led on at 100%.
Default value 003 seconds
Go to this submenu pushing Mode , choose DM.DE with + and - and push Enter . Use + and - to select the desiderate
value and push Enter to confirm. Time is setted in seconds, the value start from UNL (unlimited) to 999.