Advertisement
1. Auger drive head
5.
Stop the engine.
6.
Secure the bowl to the drive head with the bolt
and nut supplied with the auger drive head
(Figure
3).
1. Bolt
2
Reading/Storing the
Documentation
Parts needed for this procedure:
1
Operator's Manual
1
Parts Catalog
Procedure
1.
Read the documentation.
2.
Store the documentation in a safe place.
Figure 2
2. Cement bowl
Figure 3
2. Nut
Operation
Specifications
Note:
Specifications and design are subject to
change without notice.
g003846
Width
Length
Weight
Maximum dry concrete load
Mixing and Pouring
Concrete
WARNING
When full of concrete, the bowl is very heavy
and could unbalance the traction unit. The
traction unit could tip, seriously injuring you
or bystanders.
g003847
• Never use the cement bowl on a 200 or
300 series compact utility loader without
first installing the counterweight, available
from your Toro dealer.
• Always keep the bowl close to the ground.
1.
Lower the loader arms as far as possible while
tilting the bowl upward as far as possible.
2.
Add up to 200 lb (90.7 Kg) of dry concrete
mixture.
3.
Move the throttle lever to the fast position
(rabbit).
4.
If your traction unit has a speed selector and
flow divider, move the speed selector lever to
fast (Rabbit), and the flow divider control to the
10 to 11 o'clock position (20 to 30 rpm).
5.
Push the auxiliary hydraulics lever away from
the operator grip to mix the concrete and add
the appropriate amount of water.
6.
When the cement is sufficiently mixed, move the
auxiliary hydraulics lever to neutral and drive
slowly to the work site.
7.
Tilt the bowl forward and pull the auxiliary
hydraulics lever to the operator grip and hold it
to dump the concrete.
8.
When finished using the bowl, wash it out before
the concrete sets.
3
25.15 inches (64 cm)
18.25 inches (46 cm)
75 lb (34 kg)
200 lb (90.7 kg)
Advertisement
