Advertisement
Safety and Instructional
Decals
Safety decals and instructions are
easily visible to the operator and are
located near any area of potential
danger. Replace any decal that is
damaged or lost.
1. Tipping hazard—the maximum load while driving the
machine is 91 kg (200 lb).
100-4664
Installation
1
Installing the Cement Bowl
onto the Auger Drive Head
Parts needed for this procedure:
1
Cement bowl
2
Bolt
2
Nut
decal100-4664
Procedure
1.
Raise the loader arms so the drive head clears
the ground and stop the engine.
2.
Manually rotate the auger drive head up, until
you can install two bolts into the holes on both
sides of the cradle arms, securing the drive
head. Secure each bolt with a nut
1. Auger drive head
2. Cradle arm
3.
Start the engine.
4.
Maneuver the drive shaft into the collar on the
back of the bowl
2
(Figure
Figure 1
3. Nuts and bolts
(Figure
2).
1).
g003845
Advertisement
