Electrolux EN3854MFX User Manual page 22

22 www.electrolux.com
Problem
The compressor operates
continually.
The compressor does not
start immediately after
pressing the FastFreeze
or after changing the tem‐
perature.
Water flows inside the re‐
frigerator.
Water flows on the floor.
Temperature cannot be
set.
The temperature in the
appliance is too low/too
high.
Possible cause
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The FastFreeze function
is switched on.
This is normal, no error
has occurred.
The water outlet is clog‐
ged.
Food products prevent
water from flowing into
the water collector.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The FastFreeze or Shop‐
pingMode function is
switched on.
The temperature regulator
is not set correctly.
The food products tem‐
perature is too high.
Many food products were
stored at the same time.
Solution
Refer to "Operation"/"Control
panel" chapter.
Wait a few hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "FastFreeze func‐
tion".
The compressor starts after
some time.
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
Attach the melting water out‐
let to the evaporative tray.
Switch off FastFreeze or
ShoppingMode manually, or
wait until the function resets
automatically to set the tem‐
perature. Refer to "Fast‐
Freeze or ShoppingMode
function".
Set a higher/lower tempera‐
ture.
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.