Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Dancover PRO XL
Summary of Contents for Dancover PRO XL
- Page 1 Manual Storage Tent PRO 3,5 Series PVC/PE 16-12-2019...
-
Page 2: Safety Advice
Note: Marquees are intended for events and other arrangements and are as such only meant for short term temporary assembly and the following disassembly. Dancover warranty applies only to the normal use of the Product, normal wear and tear excepted, in accordance with written use instructions or manual. - Page 3 Warning 1. In order to avoid being rusted by air, oil is covered on the surface of the pipes. Before setting up the tent, please remove the oil carefully first to keep the cover clean. 2. Take note that the tent needs to be handled carefully to avoid damage. 3.
- Page 4 Part no. 3.5x8m 3.5x10m Frame pole 1600mm 50-50 Frame pole 1880mm 38-38 Groundbar 1380mm 38-38 Roof support 1730mm 25-25 Frame pole 1600mm 50-50 Diagonal support 1720mm 32-32 3-way connector 54-42/3 rings 3-way connector 54-42/2 rings Diagonal support 800mm 32-32 4-way connector 54-42/4 rings Female doorbar 1835mm 32-32...
- Page 5 Part no. 3.5x8m 3.5x10m Strenghten bar 1845mm 32-32 3-way conntector 54-42 4-way connector 54-42 3-way connector for corner 3-way connector for corner 3-way connector for sidewall 2-way connector for endwall Strengthen bar 980mm 32-32 Bracket Groundbracket Strengthen bar 1855mm 25-25 Turnbuckle for door 4610mm Turnbuckle for...
- Page 6 Part no. 3.5x8m 3.5x10m Turnbuckle for side 3700mm 10x350mm Spiral peg Small peg Bungeeball long M6 wingnut Screw M6x30mm Screw M6x45mm Screw M6x65mm M6 nut Spanner Tie down Steel clip Screw M8x50mm Screw M8x65mm M8 nut 16x600mm 16-12-2019...
- Page 7 Part no. 3.5x8m 3.5x10m M12 washer M12 nut Screw M12x48mm Screw M12x65mm Sheaved block 1 wheel Sheaved block 2 wheel Ratchet stape Roof Endwall 16-12-2019...
- Page 8 Part 31 Part 32 Part 33 Part 34 Part 35 Part 39 Part 40 Part 41 Part 43 Part 44 Part 45 Part 46 M6x30 M8x50 M8x65 M6x45 M6x65 M12x48 M12x65 3.5x8-10x3.3m storage pro Wing nut Screw Screw Screw Screw (Ø42) Screw (Ø54) Washer Screw...
- Page 9 tubes, tent and accessories... etc. are present and the same as the list. Assemble the framework of rooftop by joining the portion (7, 8, 9-1, 10-1) together with poles (1, 2, 4, 5, 6, 12) NO. 11 is on four corners for diagonal pipe. across through each section as below.
- Page 10 Attach the other supported poles (1, 2, 11) to the joints, built-up the framework. NO. 11 is on four corners for diagonal pipe. You facilitate the assembly and dismantling by pulling the roof with ropes on tent frame. Use the steel clips to fasten the cover to the frame.
- Page 11 Spread the wall panel and door panel attach to framework by using the bangee cords clasping the frame to grommets that is construct over the wall panel and door panel to ensure stability. Also use the short pegs to fix the doors to the ground.
Need help?
Do you have a question about the PRO XL and is the answer not in the manual?
Questions and answers