Advertisement
Remove the gimbal clamp
from the camera.
6. Flight
For a safe take-off, make sure that the Aircraft Status Indicators blink green slowly (using RTK* or GNSS for positioning).
Takeoff
OR
Combination Stick Command to
start/stop the motors
Landing
Left stick down slowly until you touch the ground
Hold for three seconds to stop the motors
Spinning propellers can be dangerous. Stay away from spinning propellers and motors. DO NOT start the
motors in confined spaces or when there are people nearby.
Always keep your hands on the remote controller when the motors are spinning.
Stopping motors mid-flight: Perform the CSC to stop the motors. This feature can be enabled in DJI GS Pro.
Only stop motors mid-flight in emergency situations when doing so can reduce the risk of damage or injury.
* RTK positioning is recommended. If using the DJI Pilot app, go to Camera View >
select a method for receiving RTK signals. If using the Mobile SDK, refer to SDK documents on RTK configuration.
7. Start Operations
Create a 3D Map mission
Specifications
● Aircraft
Max Service Ceiling Above Sea Level
Max Ascent Speed
Max Descent Speed
Max Speed
Power on the remote
controller and the aircraft.
Left stick (in Mode 2)
up slowly to take off
Perform the mission
19685 ft (6000 m)
6 m/s (automatic flight); 5 m/s (manual control)
3 m/s
31 mph (50 kph) (P-mode); 36 mph (58 kph) (A-mode)
Import photos
Launch the app.
> RTK to enable Aircraft RTK and
Composite a map
Advertisement
