Page 1
E N G I N E E R E D W I T H T H I N P L A T E P U R E L E A D ( T P P L ) T E C H N O L O G Y EXTREME POWER AND ENDURANCE www.odysseybattery.com www.enersys.com...
Page 2
80% depth of discharge (DOD). A typical starting, lighting and ignition (SLI) battery can do one or the other, but not both. It is either a sprinter or a long distance runner; ODYSSEY batteries will do both –...
Page 3
• REMOVING OR DESTROYING THE BATTERY’S DATE CODE ODYSSEY EXTREME SERIES™ BATTERY WARNING – DO NOT USE ANY TYPE OF OIL, ORGANIC SOLVENT, ALCOHOL, DETERGENT, STRONG ACIDS, STRONG ALKALIS, PETROLEUM-BASED SOLVENT OR AMMONIA SOLUTION TO CLEAN THE BATTERY COVERS AND BATTERY TOPS.
Page 4
3. Inspect existing battery cables for corrosion, acid damage or insulation deterioration. Replace if deterioration is present. 4. Position your ODYSSEY battery in the battery holder and fasten firmly to the vehicle. • An optional height adapter may be used on 34-PC1500 models for installations where a Group 24 or Group 27 is required.
Page 5
If your V-Twin motorcycle is equipped with a standard 32 Amp single phase stator/alternator and you ride at a low engine rpm around town or even on long rides, the appropriate ODYSSEY battery may run out of charge due to low ®...
Page 6
11.98 Volts To prolong the life of the ODYSSEY battery, it is important that the battery is kept near full charge, approximately 12.8 volts. If there are electrical loads connected during storage, then the negative battery cable should be disconnected or an independent float charger used.
Page 7
12.84 volts or greater; recharge if necessary. Disconnect the negative battery cable to prevent any applied electrical load during storage. The ODYSSEY battery cannot freeze down to -40°C, so it can be left in the vehicle. It can be stored for 2 years or more below 25°C. Charging is required at 2 years or 12.6V (2.10Vpc), whichever comes first.
Page 8
WARRANTY: EH Europe GmbH (“Manufacturer”) warrants its ODYSSEY® batteries (hereafter referred to as “Battery”) to be free of defects in material and workmanship for the following Applicable Warranty Periods: • 2 years for Auxiliary Power Unit (APU) and other non-engine start cycling applications. • 2 years for power sports applications. • 3 years for commercial, industrial, marine and automotive applications in non-BCI sizes, and 629-DIN B-1300 and 625-DIN C-1500 in commercial applications. • 4 years for an engine starting application for PC1220, PC1350, and all BCI sizes. This warranty may vary from country to country; contact your authorized ODYSSEY® battery wholesaler or dealer for the applicable warranty. The Applicable Warranty Period begins from the date of purchase with original receipt, or, if no receipt is available, from Manufacturer’s shipping date as stated on the battery. Batteries determined to meet the conditions of this warranty will be replaced free of charge if, at the sole discretion of Manufacturer, adjustment is necessary due to defect in material or workmanship.
Need help?
Do you have a question about the ODYSSEY and is the answer not in the manual?
Questions and answers