The following instructions are supplied as a reference. For installation by a qualified electrician in accordance with national and local
electrical codes and the equipment manufacturer's assembly instruction. The suitability of this type of termination must be evaluated by
the Underwriter's Laboratories, Inc. and Canadian Standard Association for the end use application.
®
SBS
crimp contacts are for use with stranded Copper (Cu) wire only. Crimp tools recommended by APP
designed performance of the connector. Use of solid wires, alternate conductor materials, or tools not recommended by Anderson can
affect safety agency approvals of the connector and may produce unpredictable or health threatening results.
Verify that you are using the appropriate power, ground and/or auxiliary contacts and recommended tooling from Tables A, B and C:
Table A: Power Contacts Listed for Use with SBS
Contact Part
Number
Wire Size
1339G2
#6 AWG - (16mm ²)
1339G5
#8 AWG - (10mm ²)
1339G3
#10 - 12 AWG - (2.5 - 6mm ²)
NOTE: Use one of the following reducer bushings with contact # 1339G2 for smaller cable sizes. Electrical capability is derated with smaller wire sizes.
Bushing
Number
Wire Size
5912
#8 AWG - (8.4mm ²)
5910
#12 - 10 AWG - (3.3 - 5.3mm ²)
5913
#16 - 14 AWG - (1.3 - 2.1mm ²)
Table B: Ground Contacts Listed for Use with SBS
Contact Part
Number
Wire Size
1340G1
#6AWG - (16mm ²)
1340G2
#8AWG - (10mm ²)
1340G3
#10 - 12 AWG - (2.5 - 6mm ²)
NOTE: Use one of the following reducer bushings with contact #1340G1 for smaller cable sizes. Electrical capability is derated with smaller wire sizes.
Bushing Number
Wire Size
5912
#8 AWG - (8.4mm²)
5910
#12 - 10 AWG - (3.3 - 5.3mm²)
5913
#16 - 14 AWG - (1.3 - 2.1mm²)
SBS® Connector
Assembly Instruction
®
SBS
50
Crimp Tool
1309G4 hand tool or 1387G1 pneumatic tool + 1388G6 die + 1389G9 locator
1309G4 hand tool or 1387G1 pneumatic tool + 1388G6 die + 1389G9 locator
1309G4 hand tool or 1387G1 pneumatic tool + 1388G7 die + 1389G9 locator
Crimp Tool
1309G4 hand tool or 1387G1 pneumatic tool + 1388G6 die + 1389G20 locator
1309G4 hand tool or 1387G1 pneumatic tool + 1388G6 die + 1389G20 locator
1309G4 hand tool or 1387G1 pneumatic tool + 1388G7 die + 1389G20 locator
®
SBS
75X
®
®
50, SBS
75X and SBS
®
75G Series
®
SBS
75G
®
are required to achieve the
®
75G Series