Before Returning For Repairs; Specifications - Schumacher Electric DSR PROSERIES DSR125 Owner's Manual

The charger is making an
audible clicking sound.
The measured current is
much lower than expected.
While charging the battery,
the battery stays at a certain
% (ex. <65%).
When the charger is
unplugged or the settings
are changed, the number
increases or jumps to 100%.

17. BEFORE RETURNING FOR REPAIRS

For REPAIR OR RETURN, contact Customer Service at 1-800-621-5485. DO NOT SHIP
UNIT until you receive a RETURN MERCHANDISE AUTHORIZATION (RMA) number
from Customer Service at Schumacher Electric Corporation.

18. SPECIFICATIONS

Input ............................................................................................120V AC 60Hz, 12.5A max.
Output ............................................................................................ 6/12V DC, 10A continous
The charger has a relay
that turns the current to the
battery on and off.
The charger reached the
maximum voltage and is
reducing the current.
The charger detected an
over-temperature condition
and has reduced the current
to allow the unit to cool.
The % display may not
change at a steady rate.
The battery voltage is still
high from a partial charge.
If these solutions do not eliminate the problem,
or for more information about troubleshooting,
contact customer service for assistance:
services@schumacherelectric.com
www.batterychargers.com
or call 1-800-621-5485
• 11 •
No problem, this is a normal
condition.
No problem, this is a normal
condition.
Make sure the charger does
not have the side or rear
ventilation holes blocked.
Move the charger out of the
sun and into the shade.
DO NOT UNPLUG OR
CHANGE THE SETTING.
Be patient and let the charger
finish. This is normal.
Wait for the voltage to settle
before resuming the charge.
Turn on the lights to remove
the surface charge.