Tait orca Excel Manual page 62

Radio
Indicators
Display
+ flashing
+ flashing
medium +
slow +
slow +
medium +
fast + caller's ID warble ... A call has been received but not answered. To
+ CHAN
medium +
slow +
flashing
Message Meaning
WAIT The system is setting up a call.
GO A traffic channel has been allocated for a call. Proceed with the conversation.
ACCEPTED Your status call, despatcher callback request or network service request
has been accepted.
ENGAGED The system cannot contact the party you are attempting to call because
they are busy. Try again later.
QUEUED The network has queued the call you are attempting to make. Your call
will be connected as soon as possible.
SYS BUSY The network is busy and is unable to handle your call request. Try again
later.
NOT HOME The party you are calling has their radio switched off, in do not disturb
mode or is out of range. Try again later.
DND The do not disturb function is active.
QUE Call queuing is active.
UNAVAIL Your radio is not permitted to make the type of call you requested.
UNOBTAIN The call you are attempting to make is not valid for your radio.
LED:
steady
flashing
Display messages are shown in ALLCAPS, e.g. CALL
Sound
x 3 The transmit timer is about to expire.
for 1.5
sec
flashing
x 5 The current operation has been cancelled at your
x 3
every The battery is low. Recharge or replace the battery
5 sec
x 2
Sound:
pitch: high
duration: short
Meaning
The radio is transmitting.
The radio is transmitting at low power.
Low power transmit is active.
Handset mode is active.
A function has been turned on.
A function has been turned off.
The radio has stopped transmitting because the
transmit timer has expired. Release the PTT key
before transmitting again.
The radio has access to a network and is ready to
make or accept calls.
The radio does not currently have access to a
network.
request.
return the call, give a brief press of the PTT.
Your call time is almost up. In 10 seconds, you will
be disconnected and the call will be cleared down.
Your radio is now operating in conventional mode.
The channel is busy.
You cannot transmit because the channel is busy.
Monitor is active.
as soon as possible.
The battery is too low to operate the radio. The
radio will automatically switch off. Recharge or
replace the battery.
The temperature is too high. You should stop
transmitting and allow the radio to cool down.
medium low
long ... repeating