Table of Contents
Advertisement
AMG-LP Hardware Manual
Chapter 3: Electrical Specifications and Installation
W A R N I N G : Electrical installation must be performed by properly qualified personnel.
Electrical installation requirements will vary depending on product options. Installation instructions in this
section are for AMG-LPs equipped with standard Aerotech motors intended for use with an Aerotech motion
control system. Contact Aerotech for further information regarding products that are otherwise configured.
Aerotech motion control systems are adjusted at the factory for optimum performance. When the AMG-LP is
part of a complete Aerotech motion control system, setup usually involves connecting the AMG-LP to the
appropriate drive chassis with the cables provided. Labels on the system components usually indicate the
appropriate connections.
If system level integration was purchased, an electrical drawing showing system interconnects has been
supplied with the system (separate from this documentation).
The electrical wiring from the motor and encoder are integrated at the factory. Refer to the following sections
for standard motor wiring and connector pin assignments.
W A R N I N G : Operator access to the base and tabletop must be restricted while connected to
a power source. Failure to do so may cause electric shock.
D A N G E R : Remove power before connecting or disconnecting electrical components or
cables. Failure to do so may cause electric shock.
W A R N I N G : Applications requiring access to the stage while it is energized will require
additional grounding and safeguards. The System Integrator or qualified installer is responsible
for determining and meeting all safety and compliance requirements necessary for the
integration of this stage into the final application.
www.aerotech.com
Electrical Specifications and Installation
Chapter 3
21
Advertisement
Table of Contents
