Table of Contents
Advertisement
AMG-LP Hardware Manual
Chapter 2: Mechanical Specifications and Installation
W A R N I N G : AMG-LP installation must be in accordance to instructions provided by this
manual and any accompanying documentation. Failure to follow these instructions could result
in injury or damage to the equipment.
2.1. Unpacking and Handling the Stage
D A N G E R / H E A V Y : Manually lifting and moving the stage requires a minimum of two
people on either side of the stage. Refer to
Do not attempt to lift heavy loads single handed.
l
Follow the lifting instructions and only manually lift from the specified surfaces (if lifting
l
hardware hasn't been supplied).
Do not use any of the cables as lifting points.
l
W A R N I N G : It is the customer's responsibility to safely and carefully lift the stage.
Make sure that all moving parts are secure before moving the AMG-LP. Unsecured moving
l
parts may shift and cause bodily injury.
Improper handling could adversely affect the performance of the AMG-LP. Use care when
l
moving the AMG-LP.
Lift the stage by the yoke. When moving the stage, do not lift or support the stage by the
l
optics cell.
N O T E : If any damage has occurred during shipping, report it immediately.
Lifting Instructions
Carefully remove the AMG-LP from its protective shipping container. Gently set the AMG-LP on a smooth,
flat, and clean surface.
Before operating the AMG-LP, it is important to let it stabilize at room temperature for at least 12 hours.
Allowing it to stabilize to room temperature will ensure that all of the alignments, preloads, and tolerances are
the same as they were when tested at Aerotech. Use compressed nitrogen or clean, dry, oil-less air to
remove any dust or debris that has collected during shipping.
Each AMG-LP has a label listing the system part number and serial number. These numbers contain
information necessary for maintaining or updating system hardware and software. Locate this label and
record the information for later reference.
Shipping Clamps
Before the stage can be operated, remove all of the red anodized shipping brackets (refer to
Save the shipping brackets to be used for long-term storage of the stage or return shipping for service.
www.aerotech.com
Mechanical Specifications and Installation
Section 1.3.
for stage mass specifications.
Chapter 2
Figure
2-1).
13
Advertisement
Table of Contents
