Installation And Connection; Statutory Requirements; Preparing To Install - Siemens EC6A5IB90A User Instructions

5Installation and connection

S tatutory requirements
I n s t a l l a t i o n a n d c o n n e c t i o n
This installation must conform with the following:
Manufacturer's Installation instructions
■
Local Gas Fitting Regulations
■
Municipal Building Codes
■
Refer to AS/NZS 5601.1 for Gas Installations
■
S.A.A. Wiring Code
■
Local Electrical Regulations
■
Any other statutory regulations
■
Installation and connection

Preparing to install

Refer to AS/NZS 5601.1 for piping size details. These
built-in cooktops are intended to be inserted in a
benchtop cutout.
Do not stick the cooktop onto the worktop with silicone.
Only an officially authorised technician should connect
the appliance.
Before you begin, turn off the gas and electricity supply.
Before connecting the unit, check whether the local
connection conditions (type of gas) are compatible with
the unit's setting. Observe any special conditions
imposed by local suppliers (utilities). The specifications
of this cooktop are stated on the data label located on
the bottom of the cooktop base.
A duplicate data label is supplied for adhesion to an
accessible location near the hotplate if the data label on
the base of the hotplate cannot be accessed when the
hotplate is installed.
en
5