Powersave Function; Cleaning Mode - Record FlipFlow TWIN User Manual

5.6

POWERSAVE function

If the FlipFlow is not used for a certain time, the lights turn off and switch back on automatically for the
next cycle.
5.7

CLEANING mode

This mode allows the FlipFlow to be cleaned without triggering an alarm while keeping the entrance
door closed and locked. This mode can be activated by pressing a switch on the FlipFlow. This switch
is provided by the customer.
Exiting cleaning mode
This mode can be exited in two ways:
▪ The service personnel deactivate this mode themselves before the set time expires and the
FlipFlow goes back to the operating mode previously set.
▪ The Flipflow sends an audible signal indicating that the set time has expired, after a second time
delay, the FlipFlow will prepare to close. If the tunnel is empty, it will go back to the previous op-
erating mode. If not, the alarm will continue to sound until the service personnel has evacuated
the tunnel.
BAL_FF_TWIN_EN-USA_2V1_REC_121-006454534
NOTICE
Configurable:
• Activation / deactivation of functions.
• Setting the idle time delay.
NOTICE
Configurable:
• Setting the cleaning time duration
• Setting the warning time duration
Operating modes and functions
Status of the FlipFlow
▪ Illumination is on
▪ LED-Strips are off
▪ Entrance pictogram is red
▪ Entrance door is closed and locked
▪ Exit door is open
5
20/ 31